![]() It then automatically pairs with your nearest Bluetooth device. It is very simple to set up- you just have to remove the control pad from the headband and switch it on by holding the middle button down until it flashes red. It is multi-functional so you can get it to work with your choice of music, television, or audiobooks through a wireless Bluetooth connection. It features soothing sounds to help you fall asleep faster and remain in a state of deep sleep. IS JUST A MATTER OF TRIAL AND ERROR KEEP AT IT AND SING LIKE A BIRD HOPE IVE HELPED YOU CHARLES ITS ALWAYS WORKED ON MY CLOCKS.If you are looking for uninterrupted space, for watching TV, reading a book, or just listening to music without disturbing your partner-this creative headband style alarm clock works pretty well. IF THE HAMMERS ARE TOO FAR BACK BEND THEM GENTLY TOWARD THE RODS AND RELEASE IF YOU GET A SOFT SMOOTH DONG YOURE THERE. NOW IF YOUR HAMMER STRIKES ARE DULL THIS USUALY SUGGEST ONE OF TWO REASONS FIRST AND MOST OBVIOUS CHECK YOUR HAMMER SHOE ARE THEY WORN AND HARD IF SO CHANG THEM YOU CAN PURCHASE NEW HEADS QUITE CHEEPLY IF HOWEVER THE SHOES ARE GOOD THEN IT IS SIMPLY A MATTER OF DISTANCE BETWEEN THE BAR AND THE HAMMER TOO CLOSE AND THEY WILL BE DULL TO FAR AND YOU WILL EITHER GET NOTHING OR JUST A TINK SOUND THE WAY TO CORRECT THIS IS SIMILAR TO THE ALIGNMENT IF THE HAMMERS ARE TOO CLOSE GENTLY BEND THEM UPWARDS TOWARD THE DIRECTION IN WHICH THEY GO WHEN RISING TO STRIKE DO THIS UNTILL WHEN YOU RELEASE YOU GET A NICE DONG SOUND. HI CHARLES I HAVE BEEN PURCHASING CLOCK FOR SOME TEARS NOW AND HAVE ENCOUNTERED THIS PROBLEM BEFORE, FIRSTLY IF YOUR HAMMERS ARE NOT MEETING THE BARS PROPERLY LIKLEY IT S A SIMPLE ALIGHNMENT ISSUE TO CO,RRECT SIMPLY BEND EACH HAMMER ROD IN OPPSITE DIRECTION USIN MINIMAL FORCE SO IF YOUR HAMMER COMES DOW TO THE LEFT OF YOU BAR THEN BEND IT TO THE RIGHT ONLY SLIGHTLY MORE THAN LEVEL WITH THE ROD IF WHEN YOU RELEASE THE HAMMER AFTER BENDING YOU FIND IT IS STILL NOT STRAIGHT THEN REPEAT BENDING PROCESS MOVING FURTHER THEN RELEASING UNIL YOU HAVE THE CORRECT ALIGNMENT. ![]() I know that for the 4th quarter there is additional stuff that goes, but the balk seems to be not at the time of any of that. ![]() I intend to take the face off so I can oil some areas that I just can reach otherwise, but would only tackle that if you think I am going in the right direction. My guess is there is some dirt/dried oil some place that is the problem as with the little smooth push it goes there is no clicking of any additional mechanism releasing. Its like there just isn't enough oomph (technical clock term) but the spring is wound completely. If I push the gear that drives that it continues and completes. Everything is released for the chime and it starts in on the first hammer and stalls. Occasionally on the chime for the hour it starts out but then just stops. I thought I was done but there is an intermittent problem. I oiled the little lever that ticks through the hour strike counter half gear and got the striking to end properly. Did not run when attached the pendulum but a touch to the minute hand sent it on its way. (putting my question here as it relates to chimes) I have a Hamilton wall clock cable drive from my son that was not striking and chiming properly. ![]()
0 Comments
Leave a Reply. |